How to Install Heated Grips on Scooter and Motorcycles [I Want to Know About That Part, Part 32]
Affordable heated grips are on the market these days. Enjoy a warm ride this winter. *
Easy instructions for disassembling and assembling 22mm heated grips (heated grips) and connecting the wiring. *
(Check the grip diameter before purchasing for American and some classic scooters with thick handlebars!)
1. Let's install heated grips on a modern-style covered handlebar scooter.
(You need to be able to remove the handlebar cover to replace the grips.)
(Most scooters and motorcycles use 22mm grips.)
2. Instructions for disassembling the KNC Shark 125 handlebar cover.
3. A brief explanation of the wiring for commonly sold two-stage heated grips.
(Generally, black is - and red is +.)
4. Ground the chassis and connect the - wire.
5. Use the + wire to connect the + current, which is detected by a continuity tester when the ignition is turned on.
(Make sure to use the + wire that shows a positive current when the ignition is turned on and off.)
6. Instructions for disassembling the left stock grip (including the balancer).
7. This section explains how to assemble the left heated grip and how to organize the wiring.
8. This section explains how to disassemble the right accelerator grip (switch assembly).
(The accelerator grip is housed in the switch assembly, so this section explains how to disassemble and assemble the switch assembly.)
9. After installing the heated accelerator grip, check its operation continuously while reassembling it!
(If it feels stiff, it's not assembled correctly. The accelerator is important, so be sure to check it!)
10. Connect the wiring jacks for the left and right heated grips and ground the negative wire to the chassis.
(The negative wire may not connect properly to the painted area of the chassis. You can clean up the painted area with sandpaper.)
11. Connect the positive wire correctly to the positive wire, which you previously checked with a tester.
12. Before assembling the steering wheel cover, check the operation of the heated wire and organize the wiring with cable ties.
13. Check that the heated grip is operating properly and restore the steering wheel cover to its original condition.
14. Stay warm this winter with heated grips!
Torque experience is required when using power and pneumatic tools. *
You must first learn how to assemble bolts, nuts, and screws using hand tools.
00:00 Inexpensive 2-stage heated grips explained.
01:22 How to disassemble a scooter handlebar cover.
02:38 Heated grip explanation and how to locate the positive wire.
05:14 How to disassemble the left genuine grip and balancer.
06:36 How to assemble the left heated grip.
07:48 How to disassemble the right throttle grip.
10:00 How to assemble the right heated grip.
14:35 How to connect the heated slip wires.
18:08 Operation confirmed after cover assembly.
Scooter: KNC Shark 125 (Easymax 125) -
#Heated grip installation method#Keep your hands warm in winter#Scooter heated grip 22mm