Mostly Printed CNC -MPCNC - Quick and dirty test run #4
Single Flute Upcut 1/8″ end mill.
9.53mm Depth Of cut (1/2 of 3/4″).
10mm/s feed rate, 3.5mm/s plunge (can be faster)
45% Stepover
0.4mm finish allowance
Estlcam Peel pocketing strategy
DW660 full speed
The cut went well you can just hear it starting to chatter but look at the shavings, real nice.
Getting ready for some overlap joints for a picture frame. I want to try all the cuts at once on the LowRider on a 8’x3.5″x3/4″ piece of pine so I was dialing in the settings on the MPCNC.
So have I been babying this thing the whole time or did I just get lucky?
Questions are best asked here.
https://www.v1engineering.com/forum/t...
https://www.v1engineering.com/
http://www.thingiverse.com/thing:724999