Bed Stripe Graphic for Gladiator JT Installation Instructions
Shop the product at: https://adventurelifedecals.com
Minimum application temperature +40°F
Applied decal temperature range -40°F to +180°F
*Please read the application instructions or watch the video through before beginning to apply your graphic so that you get it applied just how you want it.
It is recommended to apply this graphic in a climate controlled environment or in the shade and cool weather if a climate controlled environment is not available. This will prevent the graphic pieces from unintentionally being stretched and adhering. to the other pieces of the graphic during installation. It can still be applied in warm weather and direct sunlight, but be extra careful to not stretch it vertically. This is just for the application. After it is applied, your graphic will not have any issues in sunlight, any weather conditions, or even automatic car washes.
What You Will Need:
• Water + Dish or Baby Soap
• Microfiber Cloth
• Squeegee with soft edge (included with your purchase)
• Blade (snap-blade included)
• Heat Gun or Hair Dryer (optional)
Steps:
1. Clean the area with water, dish or baby soap, and isopropyl alcohol. Dry with a lint-free microfiber cloth.
2. Spray the surface with soap+water or soap+isopropyl alcohol for the wet application.
3. Remove the graphic from the backing and slide it into place where you would like it on the bed.
Tip: Leave enough material overhanging on the top and bottom to trim the excess.
4. Use the soft edge of your squeegee to press the graphic down and push the wet solution out.
Tip: Use light pressure at first to avoid moving the graphic out of place.
5. Use the hard side of your squeegee to push the graphic into the edge between the rear panel and the plastic trim.
6. Use your blade to trim the excess material on the top and bottom. Trim on the plastic trim and not on your vehicle's paint.
Tip: Use light pressure when trimming as the blade is sharp.
7. (Optional) Warm up the material at the top and bottom with your hair dryer or heat gun to create a stronger bond.