Making a "HitBox" Controller to Save Money
The commercial fight controllers are great but they are a bit expensive.
If you're like me and are just looking to get into fighting games, then making a controller is a pretty good option.
As long as you have a Raspberry Pi Pico, you can make it out of whatever materials and buttons you want, in whatever design you want.
Here are some of the resources used:
Firmware for the Raspberry Pi & general guide: https://gp2040-ce.info/
Keycaps used 3D printed model: https://www.thingiverse.com/thing:613...
Box used 3D printed model: https://www.thingiverse.com/thing:619...
Sanwa (or equivalent) OSBF-24 & OSBF-30 buttons were used on the wooden model
Music:
Horizon Blue @ フリーBGM DOVA-SYNDROME OFFICIAL
TIMESTAMPS:
0:00 - Intro sketch
0:52 - Rationale
2:37 - Gluing pieces
5:53 - Soldering
8:37 - Final assembly
11:28 - Flashing firmware
13:28 - Key-cap V1 problems
14:43 - Final product
16:35 - A quick test
_________________________
Sam Campbell or "The Modding Room" makes no representation about the accuracy, reliability, completeness, or legality of the activities, techniques or modifications shown in this video or the results to be obtained therefrom. If you choose to engage in any activities described in this video, you could potentially void any warranty you may have on the equipment or software you use. Your actions could also be in violation of certain provisions of the agreements you have with the manufacturer(s) of the equipment or software you use. You are solely responsible for adhering to any intellectual property laws and usage restrictions applicable to such products and any other products you may use.
Under no circumstances will Sam Campbell or "The Modding Room" be responsible for any loss or damage, including personal injury or death, that may result from your engagement in the activities demonstrated in this video. You also assume all risk and liability that may result from your engagement in such activities