I Tried Rub ‘n Buff on 3D Prints… Here’s What Happened

Опубликовано: 16 Май 2026
на канале: SweetNSaur3D

41,650

434

Does Rub ’n Buff actually work on 3D prints? I tested it on two big props

Tired of using magnets for your cosplay masks? Try this instead • Struggling to Fit Large Masks and Prints o...

I finally gave in and tried Rub ‘n Buff on a couple of my 3D prints—a Mandalorian helmet and Thor’s hammer. Did it actually work? Kind of. One turned out better than I expected, the other… not so much. Here’s how it went, what I used, and what I’d do differently next time.

Featured 3D prints:
https://makerworld.com/en/models/8348...

Elastic Bands:
https://www.amazon.com/dp/B07RFK6SV9?...

Double-Sided Tape:
https://www.amazon.com/dp/B0D9VFKVB6?...
______________________________________________________

👉 Check out these amazing prints • Snorlax! #snorlax #pokemon #pokemoncommunity

👉Follow me on TikTok https://www.tiktok.com/@sweetnsaur3d?...

✉️ Like what you see?
Contact: [email protected]
______________________________________________________

#3dprint #3dprinter #3d #bambulab #x1carbon #filament #3dmodeling #3dart #3dartist #3dprintdesign #3dprintingworld #3dprintinglifestyle #3dprintinginnovation #3dprintingathome #3dprintinglove #3dprintingsolutions #3dprintingisfun #3ddesign #3dprinted #blendercommunity #3danimation #3dprintingmodel #3dprintingtips #ender3s1pro #creality #esun #productdesign #3dprinting #3dprintingtips #top5tips #3dprintingservice #3DPrinting #RubnBuff #CosplayProps #MandalorianHelmet #3DPrintedProps #DIYFinish #SweetAndSaur3D #PrintFail #PrintWin #3DPrintTips #starwars #mandalorian #disney #disneyplus #thor #godofthunder