How to make the illusion of infinite mirror from the frame.
ЯндексПереводчикТЕКСТСАЙТКАРТИНКА
jeka57
РУССКИЙ
1844 / 10000
АНГЛИЙСКИЙ
Hi all.
In this video I will show you how from the conventional photo frames to make the illusion of infinite mirrors. If you like it already, and you want to make the same frame, the inspection video to the end and you will succeed. Here we go.
For Assembly, we need the usual photo frame, mirror, led strip light, better color, mirror film and a little tool.
For a start, dismantle the picture frame and retrieved from a glass.
Well then you need to clean the glass and mirror that on the surface does not remain traces, the better you clean the surface, the less traces will be visible in the final result.
Next, take the mirror film and cut slightly larger than the glass.
The prepared solution of water and shampoo is sprayed over the surface of the glass to avoid dust and small pieces between the glass and the film.
Then glue the film to the glass and using a plastic card level the surface of the film to avoid bubbles. Then cut the tape along the edge of the glass.
Since I have the led strip was very wide and heavily went beyond the boundaries of the frame, I decided to make a small furrow around the inner perimeter of the photo frame, the ribbon, the LEDs close to the glass.
Then measure out the led strip on the frame size and insert it between the glass and the frame, there is a gap in 1миллиметр.
Then insert the mirror and test our home-made for performance. And as you can see, we did it. Then finally fashionable to glue the mirror to the frame, and glue it to the back cover of the photo frame.
Now all a few moves and you can enjoy the beautiful illusion of infinite mirrors, but by remote control and colorful led strips can configure the modes and colors according to your taste.
If you liked this video and you suddenly want to subscribe, I will not mind. All the while.