SIGNAL MEASUREMENT IN SMATV SYSTEMS – Part 3
Part 1: • SIGNAL MEASUREMENT IN SMATV SYSTEMS – Part 1
Part 2: • SIGNAL MEASUREMENT IN SMATV SYSTEMS – Part...
Used for the video:
meter: https://www.dipolnet.com/R10842.htm
antenna connectors: https://www.dipolnet.com/E80342.htm
quick connectors: https://www.dipolnet.com/E8247.htm
coaxial cable: https://www.dipolnet.com/E1015_1.htm
antenna: https://www.dipolnet.com/A1515.htm
Part 3 out of 3 of the guide on how to measure signals in a TV-SAT system. In this part we show you how to measure DVB-T2 signal.
Installation on a previously assembled and set antenna is done as follows:
STEP 1 – installing the antenna on the post. The antenna has a loosened mount
STEP 2 – installation of short, temporary coaxial cable in the diplexer to connect DVB-T2 meter.
STEP 3 – connecting meter to the antenna, choosing the proper search mode, choosing location and DVB-T channel
STEP 4 – setting antenna according to meter readings (highest possible signal level and highest possible MER)
STEP 5 – tightening antenna's mount
Setting up the SAT antenna with Quatro, Unicable and Wideband LNBs was shown in the first two parts of the series.
0:00 Introduction
1:07 Setting search parameters
2:00 Antenna setup
3:14 Searching for and previewing SAT channels