Shop Made Tools | Making 60mm Open End and C Type Pin Spanners
Multi grips, multi-grip pliers, water pump pliers, whatever you might know them as, are a common tool in tool boxes and workshops. Usually the tool of last resort, although to some DIY practitioners, they can be the tool of first resort, but they can be very handy. In this workshop, 5c collets, are used in either block holders for milling, or in the lathe for turning. To date, 5c collets, have been tighten in place using multigrips which are marking the holders. This episode is going to be about making a 60mm open end spanner to tighten the collet chuck in the lathe and a c type pin spanner to tighten the ring of the block holder.
Chapters
00:00 Introduction
03:00 Making a 60mm open end spanner
07:35 Making a c type pin spanner
11:27 Different c- and pin spanner types
15:18 Finished spanners in use
16:17 Conclusion
Disclaimer.
This video is intended for generating ideas or entertainment purposes only. Should you choose to make or do anything as depicted on this channel you do so at your own risk. Making and the use of tools can be extremely dangerous. The equipment and methods I use may not work for you and by no means do I suggest that my methods of working are correct. Your shop safety is your responsibility, so I therefore accept NO responsibility or liability for any injuries or accidents you may have if you attempt to replicate the things that I do.
#whitedoggarage #shopmade #pinspanner