Cisco 4400 Wireless Controller Not Showing All Disabled Clients on the Web Interface
This video walks you through how to manage your disabled client list (exclusion list) through the command line console of a Cisco 4400 wireless controller The web interface only shows 80 disabled clients. Removing clients from the list can be a problem if the mac address is not listed in the first 80 clients. The console list also shows the full description of each client as opposed to the three characters shown on the web interface. The command line is shown below in case you are unable to see it clearly on the video.
show exclusionlist
config exclusionlist delete 00:00:00:00:00:00 (mac address)
save config
Click here to subscribe http://bit.ly/ngdysub1 and don't forget to select the notification bell!
Mark Jenkins is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com
Disclaimer:
Due to factors beyond the control of Mark Jenkins, I cannot guarantee against improper use or unauthorized modifications of this information. Mark Jenkins assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Mark Jenkins recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Mark Jenkins, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Mark Jenkins.