Nux Mg300 Mk II Guitar Processor Workflow Tutorial | Nux Tutorial |
🎸 1. Getting Started: Power & Connections
Plug the included 9 V DC adapter into the pedal’s DC input.
Connect your guitar to the INPUT (¼″ jack).
For output, use either:
¼″ cables to an amp or mixer (mono or stereo),
TRRS headphone jack for silent playing or streaming,
USB‑C to your computer for recording or IR editing
2. Switching On & Navigating
Find important buttons: SELECT knob, Mode/Edit/Save, Tap, Pedal, and 3 footswitches (Looper, Bypass/Tuner, Drum)
Use UP/DOWN footswitches to flip through presets; long-press both to enter the tuner
Creating a Tone: Blocks & Routing
Press EDIT/EXIT to enter editing. Navigate signal blocks (Noise Gate → Compressor/OD/Mod/Delay/Reverb) using SELECT, adjust with Knobs 1–3
Long-press a block to move its position—giving you full signal chain customization
Dial in Your Effects
Cab & IR: Load one of the 36 built‑in cab IRs or import your own. Adjust High‑Cut/Low‑Cut to center mid-range frequencies (~10 kHz cutoff works well)
Dynamics: Add compression or noise gate before drive blocks—fine-tune Threshold and Decay to control sustain and noise .
Spatial fx: Chorus, phaser, tremolo sit well before drive. Delay and reverb go after—set Delay’s sub‑division with Tap Tempo, e.g., dotted eighth for solos .
5. Expression Pedal Setup
Press PEDAL button to assign it to WAH, Drive, Amp Level, Mod, Delay, or Reverb. Calibrate pedal in global menu (hold EDIT + SAVE)
Looper & Drum Machine
Tap JAM, then use footswitches: UP for drum style, DOWN controls the looper (record, overdub, stop, clear).
Sync your loop to the drum BPM automatically
7. Save & Manage Presets
After dialing in your tone, press SAVE, name it, and choose among Presets A–D and Scenes 1–3 (e.g., clean, overdrive, lead within one preset)
Advanced Tips from the Community
“If there's too much gain accompanied by noise, then add a Noise Gate as appropriate”
“Use dry mode when connecting via USB to play Rocksmith with zero latency”
Use “Studio Direct” mode (Mode button) to bypass cab when routing to PA or streaming via USB
#nux #nuxmg30 #nuxmg300 #nuxmg400 #guitar #guitargear