Making Tracks for Treadwell Droid WED-15-77 (part 1)
Tracks required for a specific need are usually expensive! So I thought I would have a go at making my own.
The rubber is a two part mix used for making moulds, but from a test I did last year, this might be good enough for these tracks.
I drew up and 3D printed some moulds, these also included a second upper half, which was going to have the guide part moulded in.
Check out part 2:
Making Tracks: de moulding two joined together tracks
• Making Tracks: de moulding two joined toge...