Samsung A12 A125F eraphone ways,solution,charge,Mobile repair training,Phone solutions
Samsung A12 A125F eraphone ways
To see the complete solution, go to the link in the description:
https://iranmtt.ir/%d9%85%d8%b3%db%8c...
Samsung A12 capsule route
Samsung A12 A125F eraphone ways
Check software problems on SAMSUNG GALAXY A12 A125.
Software problems and sound interruption after updating or flashing the SAMSUNG GALAXY A12 A125 phone.
Hands-free symbol coming on the screen of SAMSUNG GALAXY A12 A125 Sometimes your phone's speaker may not work but your headphones work when you disconnect the accessory from the audio jack Android may not process this event and your phone is stuck in headphone mode And the speakers of your SAMSUNG GALAXY A12 A125 don't work, it means that your speaker is disabled even though you have disconnected your headphones.
Go to the sound section of the SAMSUNG GALAXY A12 A125 phone in the settings and confirm that you have not accidentally turned on the Do Not Disturb or Silent modes.
Additionally, we recommend testing the SAMSUNG GALAXY A12 A125 speaker by turning the volume down to its lowest setting and then turning it up to the maximum level. Try playing music at both levels to make sure it's not stuck.
Try the safe mode of the SAMSUNG GALAXY A12 A125 phone
Hardware problems in SAMSUNG GALAXY A12 A125
The ringtone of SAMSUNG GALAXY A12 A125 may be defective.
Low sound and distorted sound usually happen when there is dust on the ring buzzer mesh of the SAMSUNG GALAXY A12 A125 or when the ring buzzer is faulty. The speaker port of your SAMSUNG GALAXY A12 A125 is always exposed to debris while your phone It's built to withstand dust but it doesn't always hold up well to dust, this often causes your Android phone's speaker to be muffled, or worse, your phone's speaker doesn't work.
The coils or inductors of your SAMSUNG GALAXY A12 A125 may be defective.
Lack of continuity between the contacts of the bell and the coils or a problem in the connection of the bell buzzer connectors with the panel or board of the SAMSUNG GALAXY A12 A125 phone.
Error in the onboard connector of the SAMSUNG GALAXY A12 A125 alarm, but this happens in very rare cases and there is a 1,000 to one possibility that the alarm error is due to a failure in the onboard connector.
Check the buzzer of the SAMSUNG GALAXY A12 A125 using a multimeter, if it is already damaged, replace it.
If there is nothing wrong with your SAMSUNG GALAXY A12 A125 speaker make sure the terminal is properly aligned then clean the ring terminal contact pads for possible oxidation or corrosion (this may weaken the connection).
Water corrosion in the part and location of the hands-free connector of SAMSUNG GALAXY A12 A125.
Checking the flat connecting the speaker to the SAMSUNG GALAXY A12 A125 phone board (if it has a flat).
High pressure of the frame or the back cover of the SAMSUNG GALAXY A12 A125 phone due to a break on the speaker, which causes the sound of the buzzer to decrease or weaken.
Push the speaker a few times because the wires may have come loose. Otherwise, you should send it in for repair.
Your phone failed the diagnostic test and has no sound at all
It means your hardware is faulty.
Note that if you have recently purchased your phone, check your warranty. The manufacturer will fix it for you for free.
Just make sure you haven't rooted your Android phone before going to the manufacturer or store.
Also, make sure you don't drop or play with your device, which can damage the device itself. Otherwise, your warranty will be void.
IranMTT is an online media
comprehensive and updated information about mobile phones for free.
00:00 start
00:10 Samsung A12 A125F eraphone ways
00:30 SAMSUNG GALAXY A12 A125 sound problem