Revit Tutorial - Primary Pipe Support - Clamp
Part 1.7 - Piping Modeling - Revit Tutorial - Primary Support - Clamp
https://www.pipeex.org/
0:00 Introduction
0:19 Start a new generic metric model family
0:38 Add reference planes and label clamp width W
0:48 Add front view reference planes for outer edges and bolt holes
1:08 Define the gap between clamp halves as T
1:16 Create the top half clamp with a sweep
1:32 Label the bend radius as R
1:36 Define and center the main clamp diameter
2:00 Create the clamp profile and add thickness
2:22 Mirror the first half to create the second half
2:32 Check the profile and add the missing thickness dimension H
2:45 Add bolt holes
2:56 Load the lookup table
3:21 Add shared parameters like nominal diameter and description
3:33 Connect family parameters to the lookup table
3:46 Set AC as a calculated value
4:15 Add connectors and assign the primary connector
4:27 Change the category to pipe accessories
4:36 Save the family and test it in the project
4:42 Final result
4:47 Outro
#Engineering #PipingEngineering #MechanicalDesign #ProcessEngineering #AutodeskPlant3D#RevitTutorial#SoftwareTutorial#IndustrialEngineering#TechnicalSkills #DIYEngineering #TutorialVideo#InnovativeEngineering #ProductivityTips
#ProfessionalDevelopment #TechSavvy #EngineeringLife #CADDesign #DigitalEngineering #SkillBuilding #LearningResources