WHY DOES THE GEEETECH A10T NEED A THIRD EXTRUDER?

Опубликовано: 08 Сентябрь 2026
на канале: voltNik

61,572

2.4k

Geeetech A10T 3D Printer (three): http://alli.pub/6cuooa
Geetech A10M 3D Printer (two): http://alli.pub/6cuooh
New model with a 32-bit Geeetech A30T board: http://alli.pub/6cuoqm
Geetech A20M 3D Printer: http://alli.pub/6cuopn
2-in-1 Hot End: http://alli.pub/6cus2e
3-in-1 Hot End: http://alli.pub/6cus3r

Spool stand model: https://www.thingiverse.com/thing:539...
Forum: https://www.geeetech.com/forum/

➥ The voltNik project is a private project, supported by contributions from subscribers. For help: https://www.donationalerts.com/r/voltnik
♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦
ALIEXPRESS: http://voltnik.ru/aliexpress
BANGGOOD: http://voltnik.ru/bngd
♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦♦
✔ Channel website: http://voltnik.ru/
✔ Yandex.Zen: https://zen.yandex.ru/voltnik
✔ VK: https://vk.com/voltnik
✔ Telegram channel: https://t.me/voltnik_channel
✔ Telegram chat: https://t.me/voltnik_group
♦ 3D printing channel aggregator: https://t.me/ALL_3D

Timings:
0:00 - Introduction
0:28 - Multi-extruder printers
1:57 - A10T mixer
3:16 - Construction
3:54 - Kit
4:50 - Electronics
5:14 - Spool racks
5:49 - CURA printing start
6:19 - PrusaSlicer
7:17 - What else the A10T can do
7:57 - Conclusion