TubeDriver v1.3 for Windows (VST) and Mac OS X (VST&AU)
TubeDriver v1.3 for Windows (VST) and Mac OS X (VST&AU)
http://nickcrowlab.blogspot.com
TubeDriver - tube amplifier emulation plug-in for Windows (VST 32 and 64bit) and Mac OS X (VST and AU 32 and 64bit).
It's free but donations are welcomed.
Controls:
Pre EQ - High Pass, Peak, Shelf and resonant Low Pass filters.
BIAS - Adjusts tube stage’s grid bias which control the symmetry of the tube amp saturation.
DRIVE -Amount of gain applied by the tube amp.
VOLUME - Output level..
BOOST - +12 db additional gain applied by the tube amp.
BYPASS - Switch TubeDriver in bypass mode.
MONO - Switch TubeDriver in mono mode - process Left Input, output Left and Right.
PHASE - Invert phase of output signal.
HP Freq – Post High Pass Filter frequency.
LP Freq– Post Low Pass Filter frequency.
Dry/Wet– Overall Dry/Wet control.
Oversample - Oversampling Rate in realtime.
16x On Render – Oversampling Rate in Render (Mixdown) mode of host:
OFF - Oversampling Rate in Render (Mixdown) mode of host same as in realtime;
ON - Oversampling Rate have a maximum (16x) value in Render (Mixdown) mode of host.
INSTAGRAM :
/ hello.kevinridge
INSTAGRAM :
/ ridgemusicaudio
FACEBOOK :
/ hellokevinridgeofficialpage
TWITTER :
/ hellokevinridge
TWITER :
/ ridgemusicaudio
SOUNDCLOUD :
/ hellokevinridgesound
_____________________________________________________
📳 +6285777644902 (Ridge Studio)
#tubedriver #preamp #mac