✅Arduino air humidity controller full DIY
Arduino air humidity controller DIY. Arduino humidity controller project. The execution of the real project is shown in full and reduced to 44 minutes. The development of a circuit of an electrical principal design is shown. The electrical installation of modules and circuit components and mechanical installation is shown. Everything is collected in a small case with a transparent lid. The process of developing a program for the Arduino Nano controller is also fully shown. You can do diy every day.
The finished device of this Arduino project - a humidity controller or a humidity relay closes the relay contact when the air humidity exceeds the set value and releases this contact when the humidity drops below the set value by 2%. The input of the measured humidity is carried out using an encoder. To change the set humidity, you need to press the encoder knob for 1 second, then rotate the knob and follow the set value on the LED indicator. After changing this value, it is necessary to press the knob again for 1 second until the indicator switches to the mode of displaying the current humidity.
00:00 Intro
00:26 Schematic design in KiCad
05:35 Installation of the Arduino device
19:56 Designing and debugging a program in the Arduino IDE
39:35 Final assembly in the housing
42:36 Turn on the power supply of Arduino project
43:26 Diy photoshoot
Web site: https://arduino-engineer.com
/ geekmatic
You can order your own PCBs or new projects by WhatsApp +38(093) 415 82 45
or Telegram +38(093) 415 82 45
or Viber +38(067) 360 93 82
#arduino