Introduction to Waveguides using the LiteVNA, Part3, 3D Printed Horns
This video compares various 3D printed plastic horns by looking at their radiation patterns and VSWR. Also shown is a simple experiment where we attempt to compare a few different solid materials placed inside of a waveguide.
EEVBLOG thread, Experimenting with waveguides using the LiteVNA
https://www.eevblog.com/forum/rf-micr...
It was mentioned that The Signal Path channel made a video on 3D printed waveguides. The attached link takes you to what I believe they were referring to. He made a few horns and a filter. He's experimenting at much higher frequencies than I am and surface finish.
• TSP #145 - Sindoh 3DWOX 1 Review, Exp...
During this video, I show a couple of printed horns from the following link. Maybe we can test them out in the future.
https://antennatestlab.com/3dprinting
Introduction to Waveguides using the LiteVNA, Part1
• Introduction to Waveguides using the ...
Introduction to Waveguides using the LiteVNA, Part2
• Introduction to Waveguides using the ...