MacBook Pro 16" A2141 LCD Assembly Replacement How to Guide
Need parts for the 2019 MacBook Pro?
👉👉https://tekdep.com/product-category/f...
Ship us your laptop or iPad for repairs!
👉👉https://tekdep.com/repair/
Full screen repair guide of the 16" MacBook Pro 2019 A2141. Subscribe for more! We appreciate you guys
Visit Our Website To Find All Parts & Tools
👉👉 https://www.TEKDEP.com
00:00 – Intro & Overview
Intro to 2019 MacBook Pro LCD replacement, Model A2141.
00:32 – Bottom Case Removal
Remove six pentalobe screws and detach the bottom case.
01:09 – Battery Disconnection
Unplug battery management cable and remove pancake screw.
01:46 – Top Case Screws Removal
Remove T5 screws securing Wi-Fi and LCD board.
02:25 – Disconnect Wi-Fi Antennas
Unplug antennas and remove bracket with T5.
03:00 – Remove LCD Proximity Sensor
Unplug proximity sensor and remove T3 screws.
03:40 – Remove LCD Bungees & Covers
Take out hinge cover and bungee screws using T3.
04:18 – Detach Display Connector Bracket
Remove T3 screws from LCD display cable bracket.
05:16 – Remove Wi-Fi Module & Hinges
Unplug Wi-Fi module, display cable, and remove six T8 screws.
05:52 – Prep & Install New LCD
Align new LCD assembly and prepare for reinstallation.
06:35 – Secure Hinges & Proximity Sensor
Install six T8 screws and reconnect the proximity sensor.
07:11 – Reinstall LCD Bungees
Secure the four T3 bungee screws.
07:52 – Install Wi-Fi Vent Module
Feed antenna cables and reinstall module with tweezers.
09:08 – Secure Wi-Fi & LCD Board Screws
Reinstall T5 screws and plug in Wi-Fi and display cables.
09:52 – Secure Proximity Sensor Bracket
Hook in and screw down proximity/touch bar bracket.
10:44 – Reinstall Top Vent Screws
Use PH1 to reinstall vent module screws.
11:08 – Reinstall Hinge Covers
Secure hinge covers with T3 screws.
11:47 – Reconnect Battery
Reconnect pancake screw and battery flex cable.
12:18 – Initial Power Test
Plug in charger and test power, display, and charging.
12:57 – Verify Proximity Sensor
Close lid to check sleep function and reopen to confirm wake.
13:36 – Reattach Bottom Case
Align and clip in bottom case, reinstall pentalobe screws.
14:48 – Wrap-Up & Outro
Final checks and reminder to visit tech.com for parts and repairs.
Instagram: / tekdep
Facebook: / tekdep.store
Twitter: / tekdepc
Important Safety & Liability Disclaimer, TEKDEP™ / tekdep.com and the ownership assumes no liability for property damage or injury incurred as a result of any of the information contained in this website and all videos, blogs & pictures. TEKDEP™ recommends safe practices when working with electronics, batteries, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of TekDep, no information contained in this website shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of the tools, equipment, or the information contained in this website or Tekdep videos, blogs & social media is the sole responsibility of the user and not Tekdep. Only attempt your own repairs if you can accept personal responsibility for the results, whether they are good or bad and do your research before attempting any disassembly or repair, make sure you understand the risk you're taking.