CCNA:LAB No# 20 Configuration of Frame Relay in Hub & Spoke topology
Uploaded the Packet Tracer file here:
Point to Multipoint frame Relay
https://drive.google.com/file/d/0B3-H...
Point to Point frame Relay
https://drive.google.com/file/d/0B3-H...
Frame Relay Hub and Spoke Topology
https://drive.google.com/file/d/0B3-H...
Assalam-o-Alaikum
Objective:
1) We are going to create a Point to Multi-point frame relay network , for that we first we need to enable our routers to work with Frame-Relay.
2) As we all know that in Point to Multipoint Frame-Relay, all the sites and HQ, needs to be on a same subnet. So we will assign IPs to them from same subnet i.e. 200.100.100.0/24.
3) All sites and HQ needs to be connected in a Hub & spoke manner, through Frame Relay i.e. ISP and all this configuration will be done on ISP end including the assignment of DLCI numbers.
4) Verify the Frame-Relay mapping, which would already be there automatically via LMI and then activate any Routing protocol ( RiP, EiGRP, OspF) to advertise the LAN networks to each other.
5) Verify that all the sites are communicating with each other and if not then make sure they do.
6) HQ would be able to Internet Access and perform NAT process is needed because when HQ will communicate with the internet then for internet Private IP addresses are not allowed.