2013 Civic Illuminated Door Sill Trim Installation
How To Install Door Sill Trim Illumination Kit on a Honda Civic
1. Disconnect the negative battery cable from the battery.
2. Remove the passenger's front door sill trim (six clips, two hooks, and four retaining tabs.)
3. Pull away the door opening seal, and remove the passengers kick panel (two clips)
4. Remove the glove box.
5. Remove the trunk lid/fuel fill door opener cover. Remove one self-tabbing screw. Using the key, unlock the trunk door.
6. Remove the drivers front door sill trim.
7. Pull away the door opening seal, and remove the drivers kick panel.
8. Remove the drivers dashboard lower cover.
9. To protect the vehicle, attach tape to the dashboard in the areas shown. Move the shift lever to position N, and wrap a shop towel around the shift lever.
10. Remove the center lower panel.
11. Using alcohol pads, thoroughly clean the fuse case where the fuse label will attach.
12. Attach the fuse label to the door sill trim harness fuse case.
13. Attached to the bottom of the fuse box, locate the 28 pin connector. Plug in.
14. Attach the door sill trim harness connector to the vehicle connector.
15. Attach the door sill trim harness fuse case to the bottom of fuse box.
16. Secure the door sill trim harness to the vehicle harness with one wire tie.
17. At the door sill area, secure the door sill trim harness to the vehicle harness with two wire ties.
18. Continue to route the door sill trim harness along the vehicle harness, loop the connector back to measurement shown. Secure the door sill trim harness to the vehicle harness with one wire tie.
19. Route the other end of the door sill trim harness up and over to the vehicle harness. Secure the door sill trim harness to the vehicle harness with one wire tie.
20. Secure the door sill trim harness to the holes in the dashboard panel with two wire ties. If another accessory harness is already attached to the dashboard panel, route and attach the other harness below the door sill trim harness.
21. Route the door sill trim harness toward the passenger side of the vehicle, and secure it to the vehicle frame with one wire tie.
22. Route the door sill trim harness through the center lower panel opening.
23. Route the door sill trim harness through the glove box opening.
24. Align the green tape on the door sill trim harness with the hole in the glove box frame, and secure the door sill trim harness to the glove box frame with one wire tie.
25. Secure the door sill trim harness to the glove box frame with one wire tie.
26. Inside the center lower panel opening, secure the door sill trim harness to the vehicle harness with two wire ties.
27. Secure the door sill trim harness to the glove box frame and the vehicle harness with two wire ties.
28. Using alcohol wipes, clean the vehicle panel where the aluminum tape will attach.
29. Secure the door sill trim harness to the vehicle panel with two aluminum tapes. Do not attach the aluminum tape over any vehicle holes.
/ ezhondaparts
/ ezhondaparts
http://www.ezhondaparts.com