I Gave My CR-30 the Axe!!!
Description
In this video I Test out Vision Miner Nano Adhesive on the belt and print a Viking Axe.
After brushing on a fairly heavy coating of vision miner with a foam paint brush I seemed to get decent adhesion, adding additional coats did not seem to make any improvements over coat.. I can't say if this is a good or bad solution to poor bed adhesion as I'm sure there may be better ways to apply the solution..
Post Processing: I gave the handle a few coats of Minwax Polyshades "Bombay Mahogany" Satin. Trimmed it with some Brass model paint, and layered a few shades of Sophisticated Finishes and weathered.
Links:
Vision Miner: https://visionminer.com/products/nano...
Minwax: https://www.lowes.com/pd/Minwax-PolyS...
Sophisticated Finishes: https://www.misterart.com/crafts/deco...
Filament: Polyalchemy FX Walnut & Elixir Silver
https://www.printedsolid.com/products...
Files
Thingiverse: https://www.thingiverse.com/thing:449...
**Support the channel**
Affiliate links:
Creality - https://www.creality3dofficial.com?sc...
Slice Engineering - https://www.sliceengineering.com/NAK3...
T-shirts!!!!: https://teespring.com/stores/nak-3d-d...
Amazon wishlist: http://a.co/8j2HOh7
If you're feeling generous and would like to support the channel and future development.
https://www.paypal.me/NAK3DDesigns
Contact us at : [email protected]
Tags
#3DPrinting #3DPrinter #CR30 #Creality #Creality #3dprintmill #3dConveyor #NaomiWu #SexyCyborg #Vikings #VisionMiner