The FSP HyperK HP600S with a missing HDD power cable
What was supposed to be a quick video somehow turns into a feature length fiasco as I attempt to perform the incredibly basic (you would think) task of giving an FSP HyperK PSU some new hard drive power connectors.
0:00 - Introduction
4:40 - The plan
5:44 - Foreshadowing???
8:53 - Foiled by non-existent foil
11:39 - A cable-tie caper
15:30 - Dust Bunnies-B-Gone
16:54 - About that sleeving...
20:47 - Back to the original fault
22:08 - Restarting from square one
24:19 - Thoughts on joining the wire
26:40 - Soldering it all
29:00 - A warning regarding spikes
30:23 - Heatshrink time
36:51 - The shadows start catching up
38:12 - Correct, but at what cost?
38:44 - Where the fun begins
41:07 - Something isn't quite right...
45:28 - This is the end! Or is it?
46:14 - A new hope
50:41 - Connector + tooling details
54:19 - Back to the PSU
55:30 - The right connector this time
57:43 - Doing it the dodgy-bodgy way
1:00:00 - Finally, the end is in sight
1:04:49 - Conclusion
(Yes, this video ID string starts with "uwu". Yes, I think that's hilarious. You are now blessed/cursed with that knowledge.)