Tornado OSD Maiden
Took my time installing this. Wanted to make sure everything was good to go. The next day was perfect, almost no wind. The test went well! I just took it over a mile out for the test run. I really like this OSD. One small problem is when in PA mode and when I give it some manual input to turn, it wants to go back to the heading before. "PA Heading Hold" is on in the menu but I didn't think it would hold the same heading the whole time even after manual input to change heading. I just have to turn it off for a second, turn to new heading and then activate PA again. When I start to turn at around 1:30, you can see the lock icon above the heading go away and come back. That's me trying to go one way and the OSD trying to go the other. Its no big deal to me really. I guess this is normal? Other than that and the TF icon not blinking when its recording data to the card, this OSD is working very nicely and I really like it! Now, just need to work on getting RSSI feed from the FrSky Rx...
Check out all the great info on this OSD on RC Groups: http://www.rcgroups.com/forums/showth...
Equipment:
Tornado OSD with 1.03FW
Turnigy 9x with FrSky DJT Module/FrSky 7dbi patch and D8R II Plus Rx/dipole antennas.
Boscam 200mw 5.8ghz Video Tx with DIY cloverleaf antenna.
Boscam RC305 Video Rx with DIY 8 turn helical antenna.
Bixler 2 with D2826-10 1400kv and 7x5 APC.
7 inch LCD with DIY sun shade.
HK Blue Series 30a ESC.
Turnigy 2650mah 3s.
Sony Super HAD II flight camera.
Mobius ActionCam.