New Hardware from PCBWay for my Diy Partial Hand Prosthetic!
PCBWay Printed me a set of parts to build a new version of my prosthetic in mag aluminum. the parts are so much lighter than the stainless and Pa-12 parts that ive been using for the last little bit.
the parts came out great! and I think that this is how I am going to be able to offer this device in a kit format.
I was very impressed with the price that the set of parts ended up totaling, super reasonable for what i was getting.
I you have a project that you need to have printed in metal, check out their service. if you use my code below, I will receive a small commission and it will encourage PCBWay to continue to work with my channel.
https://pcbway.com/g/2pH3n2
So Far these parts are working out great, I have 1 set Machined and assembled. in the next couple of weeks I will be working with Cerakote using their low friction coating on these parts to hopefully increase the service life and decrease the operating friction. I will show this process in the near future. lmk what you think. thanks for watching!