Selective z-probe auto-leveling buttons Repetier firmware WIP
These buttons make it easy to zprobe autolevel on strange but level objects. This video is made to show a small hiccup in the works.
http://forum.repetier.com/discussion/...
The buttons work, but after adjusting the max z height (to avoid collisions) it doesn't home properly until you change the eeprom. I think I need to set a second value besides just maxZ.
basically you are suppose to set 3 probe points and then autolevel...then when finished you set the "select tool 1" button to reset the probe points and probe height.
Also I need a good name for this feature. "selective z-probe leveling" is the best I could come up with...I'm bad at naming things.
https://3dprint352.wordpress.com/