DIY Heat Set Insert Press!

I tricked my label maker into printing this!

This is how I anodize aluminum in 60 seconds!

Anodize Your Own Aluminum Parts!

Spray painting with a custom stencil

DIY "hot blued" steel parts

Simple and Effective Bearing Setup

Once you see this, you'll never go back!

Shop made press brake build

Hex machining on a manual mill

Shop made metal rod bender

This is how I made my own springs!

This is how you cut a radius on a mill!

Custom mechanism demo

Cheap and Easy! Remove burn marks in seconds!

This $5 tool needed an upgrade.

Fixing the bearing preload on my mill spindle (PM-25MV)

T-slot rail design tip: bolt/pin combo

Not your average actuator!

Using pins in assembled 3D prints

How strong are these little stepper motors?

What would you use this actuator for?

Check out this old machinist trick!

Z offset and print layer height

DIY Heat Set Insert Press!